Tutor
•
1 Message
3G Microcell - 3G Red Light Flashing
My GPS, Ethernet, and power light are on with a solid green. My 3G light is a solid red that flashes every three seconds. I use a Netgear router/modem; honestly, I'm not sure what a modem or router looks like but I plugged the microcell's ethernet into the Netgear. I've tried disconnecting then reactivating the microcell. No luck.
Any advice on how to troubleshoot this issue would be awesome. I live in the countryside where cell phone reception is severely limited. Thanks!
midget3376
Teacher
•
11 Messages
10年前
I have had it where the 3G light is flashing red and I still have a signal. It usually fails after that.
Mine is currently solid green.
It lost its Internet signal, yesterday (the modem took a short break). It flashed green (and I had no signal) for about 20 minutes and went solid green and I had a connection.
0
0
midget3376
Teacher
•
11 Messages
10年前
BTW... I woke up a flashing red light and no connection. Turned off for 30 seconds before I left for work. Green when I got home.
0
0
mdumond
Voyager
•
1 Message
10年前
I have found the reason why my ATT microcell 3G bars blink red. I am not sure if this is everybody's issue, but it certainly is mine.
If my microcell is connected to a Gigabit Ethernet (GbE or 1 GigE) network, i get the flashing 3G bars after a reboot.
If I connect to a 100 Mbit/s network, all is good.
I basically had to convert my gigait ethernet network to 100Mbit using a 100Mbit switch.
Hope this helps.
0
0
TR3
Contributor
•
3 Messages
10年前
So, I recently had same problem as everyone else > 3g red light flashing. I reset both my router and modem and unplugged microcell. For 24 hours after doing this, it worked. Now, the 3g red light flash is back and NO MCELL! My router is the Cisco E4200 and Modem is the Actiontech MI424. I changed the MTU as referenced on line in an attempt to fix the problem. No dice. Is there a solution? Or do I now own a door stop?
FWIW: I also am using the VZ network extender in my house as we are on VZ as well as at&t. The VZ NW extender works and has worked from the begining. So, I am no expert but the problem seems to be with Microcell.
0
0
midget3376
Teacher
•
11 Messages
10年前
0
0
OttoPylot
ACE - Expert
•
18.5K Messages
10年前
0
0
TR3
Contributor
•
3 Messages
10年前
Same concept as AT&T Microcell but used on Verizon network. In my family, I am only one on VZ. Wife/kids on AT&T. My VZ extender has worked from the start. Microcell, not so much. Since my post, I reset modem/router twice and so far (since Sunday) I have MCell. IDK, I hold my breath and check the front of the Microcell daily to ensure 3g is green.
0
0
zaydon
Teacher
•
11 Messages
10年前
Just waiting until the iPhone 5 is released so i can get off ATT and this microcell. Wonder if VZ will throw in an extender to switch.
0
0
TR3
Contributor
•
3 Messages
10年前
spoke too soon.. back to flashing red 3g on microcell. Is there a fix?
0
0
OttoPylot
ACE - Expert
•
18.5K Messages
10年前
0
0
Swordfish2172
Tutor
•
4 Messages
10年前
0
0
E the P
Scholar
•
216 Messages
10年前
Wasn't there a long discussion a few months back about how pushing the reset button would "brick" the device?
0
0
Swordfish2172
Tutor
•
4 Messages
10年前
0
0
OttoPylot
ACE - Expert
•
18.5K Messages
10年前
I don't recal that discussion but I haven't read everything here. I've used the reset button a couple of times and never had any problems. Can't see why they would put a reset button on the back to only have it brick the MicroCell. It's not marked Service Only. It's marked reset.
0
0
Swordfish2172
Tutor
•
4 Messages
10年前
0
0