Skip to main content
AT&T Community Forums

Voyager

 • 

2 Messages

Mon, Sep 10, 2012 7:58 PM

Will 3G Microcell work with new Iphone 5?

Is it too early to know if the Iphone 5 will work with the 3G Microcells?

Responses

parkerdt

Tutor

 • 

5 Messages

8 years ago

My new 5 doesn't connect to Microcell, wife's 4 stil connects fine.  Tried network resets and resetting the Microcell - still no joy.  So I guss I just wait.  Off to ATT tomorrow for a new SIM

 

Dave

 

Contributor

 • 

1 Message

8 years ago

Yes,

 

My Son got it work by accident.  His phone complained about no sim card.  He reseated it and it worked.  I popped the sim out of mine and AT&T M-Cell showed up on mine as well as the wife's.  Give it a shot.

Voyager

 • 

1 Message

8 years ago

dubz2045 is correct. I first went into the manage microcell page in my account and deleted the numbers that I had just upgraded to iphone 5's. I then re-added these numbers to the microcell approved numbers list. Next unplug your microcell for 30 seconds and then plug it back in and let it completely reboot. After the reboot turn off your iphone 5 and turn it back on. You should have a microcell signal then, at least I do. Just rebooting the microcell might work on its own but I cannot confirm this because I deleted the numbers online before I tried rebooting. Hope this helps everyone.

Voyager

 • 

3 Messages

8 years ago

Finally mine is working. I had to deactivate and activate again for the new software upgrade and once that completed my iPhone 5 connected fine.

 

Thanks

Contributor

 • 

2 Messages

8 years ago

When you say deactivate, do you mean completely disconnect the device in manage settings area?

 

i tried turning the Micro Cell off and rebooting then turning the IPhone off and on and no success.   I also tried toggling the airplane mode like the other poster and also no luck.

parkerdt

Tutor

 • 

5 Messages

8 years ago

Can't find anything small and stiff enough to pop the SIM card - LOL!

Contributor

 • 

2 Messages

8 years ago

Mine just showed up 5 minutes after following the steps above and then pulling out the SIM and reseating it.   Either AT&T has sent an update or just reseating the SIM does work.

jimdarcy

Mentor

 • 

70 Messages

8 years ago

the toggle fixed all 3 of my iPhone 5's!

thanks!!

Voyager

 • 

3 Messages

8 years ago

After 12 hours of reading this thread today, rebooted iPhone 5 and boom... It works. No need to reseat SIM card here

Voyager

 • 

3 Messages

8 years ago

Yes that is correct.
u2jrmw

Scholar

 • 

33 Messages

8 years ago

How can I remove and readd my phone to microcell when it is the only device?
parkerdt

Tutor

 • 

5 Messages

8 years ago

Popped out SIM with phone active - dismissed prompt asking for SIM.  Waited 2-3 mins.  Reinstalled SIM.  2 mins later - voila - AT&T M-Cell

 

Obviously I have no way of knowing if they pushed an upgrade, but at least it is working now!

 

Dave

.

u2jrmw

Scholar

 • 

33 Messages

8 years ago

Great so I deactivated my microcell and now it won't reactivate. Awesome.

Contributor

 • 

1 Message

8 years ago

Just got off the phone with At&t tech support for 3G microcell, according to this guy the entire system crashed with all of the Iphone 5 registrations. They will be updating registrations throughout the night and should be able to connect shortly. He also said there is no incompatibility or problem with IPhone 5 or the microcell. No need to reboot or re register, also has nothing to do with the new sim cards.

rbraddes

Teacher

 • 

8 Messages

8 years ago

Does anyone else see "4G" instead of the normal "3G" next to "M-Cell" at the top of their phone?

 

I've never seen this before, but I'm also upgrading from an iPhone 4 which didn't have the 3.5G chip.

Get started...

Ask a new question