- AT&T Forums Home
- /
- U-verse Forums
- /
- U-verse Voice (VOIP)
- /
- Setup and Self-Install
- /
- Re: House Hold Phone Wiring Issues
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
House Hold Phone Wiring Issues
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-08-2011 10:36:55 PM
I'm not sure What to do but I knew this was coming. The tech that ran the RG to NID did a good job but I don't think they grasped the houses wiring config and it might be an Issue. the wiring ran to 9 location's Only 3 devices are used now but the tech tapped the main house line the RG has to power up the 7 lines not in use and this is where my mess begains. I start messing with it just looking and the RG goes down so I know I found my big problem.
Re: House Hold Phone Wiring Issues
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-09-2011 05:26:02 AM
Sounds like you have a wiring job on your hands.

Re: House Hold Phone Wiring Issues
[ Edited ]- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-09-2011 01:55:48 PM - edited 05-09-2011 01:57:22 PM
jfw wrote:Sounds like you have a wiring job on your hands.
Yeah I plugged my base to my newer phones into the RG leaving the line connection unhooked since I use the base and handsets mostly till I get the rest straight.








