12-31-2012 09:24:02 AM
Yesterday I decided to figure out how to use another router as a switch to plugin my HTPC to the network. What I originally did was take a router and connected the main uverse stb and the HTPC to the router. This worked great except for 2 things. 1 - I couldn't connect to the DVR from other STB's in the house and 2 - Since this router was on another subnet (192.168.2.*) I couldn't connect to my HTPC from a computer connected to the 2Wire (3800HGV-B) although I could connect to my PC from my HTPC.
After reading instructions (http://forums.att.com/t5/Residential-Gateway/U-ver
Here's the problem. Every 10 minutes or so the TV loses signal. It basically freezes and If I don't change the channel, the blue screen comes up saying the signal was lost. If I change the channel, and change it back, the blue screen never comes up and there's basically no interuption aside from the few seconds I missed.
Any ideas on what I can do to fix the cutting in/out problems?
Solved! Go to Solution.
12-31-2012 09:30:54 AM
12-31-2012 09:43:14 AM
Originally I was using the main DVR and another TV connected to the router, but it was assigning IP's to the STBs on its own. Everything was working great. The only reason I wanted to change it was to be able to connect to the HTPC from my computer that was directly connected to the RG. Another problem was that the TV in my office (also connected to the RG) was not able to browse the DVR, but that wasn't really a huge deal.
12-31-2012 04:35:49 PM
01-01-2013 10:53:16 AM
Yes I did try that but it didn't work.
Last night I decided to switch out the D-Link router for an older Linksys one and it solved the problem. I'm not sure if it's some software on the D-Link that was causing the problems or if it was hardware failure. But everything works fine right now and we haven't lost signal since the change.
For those of you trying to get a switch working with the RG, I followed these instructions: http://forums.att.com/t5/Residential-Gateway/U-ver
01-01-2013 11:26:52 AM
Yes, you can always connect STBs/DVR to a suitable switch (or router when used as a switch), although higher performance switches are recommended. What you can't do is place the STBs/DVR behind a router that is in routing mode.