08-22-2013 10:02:12 PM
In the past week or so, when I turn my tv and uverse box off and sometimes on using the uverse remote, the box turns off, but my tv is left on with some stup tip about how to change email passwords, etc. It's something new, it's on multiple TV's and it's caused me to accidentaly go off and leave TV's powered on overnight because I didn't notice. It's very annoying, it's stupid and I want it to stop!!!
08-22-2013 10:12:17 PM
This occurs when tv is ON, box is off. Just need to turn TV off, generally happens when both devices out of sync, to sync depress OK, pic on, depress ATT top left f remote, depress power. Both units now off (no green power l on far left side of STB)
08-23-2013 04:01:09 AM
Since the Blue Screen is also your screen saver, it will appear if you've paused a recorded program for a long(er) period of time.
Scenario: You are watching a recording of Bridezillas and your long-winded sister-in-law calls you. You hit the Pause button HOPING that it'll be a short call but, alas, she rattles on. Before you know it, the blue screen with the "tips" appears. Not to fear, your program will pick up once you get her OFF THE PHONE!*
*...not that this is based on any true experience or anything....
08-23-2013 08:42:37 AM
I'm aware of what happens when the tv and box are out of sync and I have to deal with the seperately becuase I had the remote pointed in an odd direction. This is a new problem.
08-23-2013 09:14:47 AM
Think of the Blue Screen with Tips as your screensaver now. It'll either appear when your TV/STB is out of sync OR if your recording goes to 'standby'.
Either way, it's there and there's nothing you can do about it or change it. Just ignore it if it annoys you.
08-23-2013 09:26:54 AM
The TV does not turn off because it does not see the signal. The STB does not turn on because it does not see the signal.
When you press the power button the remote sends a power toggle for the STB followed by one for the TV. These should work, but the IR signal could be corrupted by ambient light. Since it is affecting both your devices, it is probably not IR corruption. Another possibility is that the remote is no longer sending both IR signals - Look at the att & TV buttons to see if the both flash when you press the power button. You can see the actual IR if you look at the transmitters with a digital camera.
If it is a sometimes thing, you do have some choices -
Carefully aim at both the STB and the TV for the whole time it is transmitting IR.
You could change the order of activity - Instead of STB - TV - You could make it TV - STB.
You could change it so it only sends for the mode selected - This lets you do the STB and TV separately - Takes more effort and concentration - But, you will be paying attention.
The last issue is - Is the problem a low signal or a high signal. Both can cause problems.
If it is a high signal try aiming at a back wall, floor or ceiling.
If it is a low signal, try fresh batteries or a Logitech Harmony remote ( It generates a stronger IR signal)
I know you do not know which of these possibilities is your problem. The only way to find out is try them.
08-23-2013 09:54:26 AM
So you're telling me that for the past four years I've been aiming my remotes correctly, and that suddently in the past few weeks i'm not. Really?
08-23-2013 10:10:24 AM
08-23-2013 10:31:50 AM