- AT&T Forums Home
- /
- U-verse Forums
- /
- U-verse TV
- /
- Features and How To
- /
- how do i connect my smart tv to wireless receiver ...
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
how do i connect my smart tv to wireless receiver so that i can get on internet
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
08-22-2012 08:35:32 AM
Re: how do i connect my smart tv to wireless receiver so that i can get on internet
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
08-22-2012 08:38:54 AM
Are you trying to connect your smart TV to your wireless network? If so, you need to connect to the wireless signal on your U-verse RG not to your wireless receiver. I would suggest that you refer to the user manual for your TV for instructions on how to connect to your wireless network.

Re: how do i connect my smart tv to wireless receiver so that i can get on internet
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
08-22-2012 09:01:50 AM
As Teasguy stated wired or wireless mine is a Panasonic with built in wireless it asked for the router name ( Usually 2wire xxx on these forums) and wireless password . (sticker on the RG stating wireless key ).
Wired should be just connect with ethernet cable to RG or back of STB if coax was used for STB installation.









