Reply
Posted Feb 23, 2013
12:41:02 PM
Viewing Foscam camera from outside my network?

I have a wireless Foscam camera which worked just fine for weeks. I was able to configure it to view it from outside my network and on my phone. This was before i got U-verse internet. Since i have switched to U-verse i am not able to view my camera from outside my network (internally it works fine using the private IP). I have setup port forwarding by reading the various posts but haven't had much luck.

 

Has anyone gotten past this issue? Do i need to revert to using my Cisco router to configure this or I should be able to set this up by just having the AT&T wireless gateway?

 

Thanks!

0
(0)
  • Rate this reply
Solved
Feb 23, 2013 7:38:37 PM
0
(0)
Tutor

Nevermind, I just had to restart my camera and now it works fine :smileyhappy:. Thanks!

Accepted Solution

Viewing Foscam camera from outside my network?

1,655 views
6 replies
(0) Me too
(0) Me too
Post reply
Replies
(6)
0
(0)
  • Rate this reply
Feb 23, 2013 12:55:28 PM
0
(0)
Expert
Please post the camera model number.

Re: Viewing Foscam camera from outside my network?

1,692 views
0
(0)
  • Rate this reply
Feb 23, 2013 2:54:35 PM
0
(0)
Tutor

Foscam FI8910W

Re: Viewing Foscam camera from outside my network?

1,670 views
0
(0)
  • Rate this reply
Solved
Feb 23, 2013 7:38:37 PM
0
(0)
Tutor

Nevermind, I just had to restart my camera and now it works fine :smileyhappy:. Thanks!

Re: Viewing Foscam camera from outside my network?

1,655 views
Solution
0
(0)
  • Rate this reply
Feb 23, 2013 9:01:40 PM
0
(0)
Expert
OK, cool, let us know if there's anything else we can help with.

Re: Viewing Foscam camera from outside my network?

1,645 views
0
(0)
  • Rate this reply
Dec 13, 2013 7:00:57 AM
0
(0)
Contributor

I’m having an issue with a Foscam camera that I just can’t figure out. I have two of them. One of them I got set up and working fine on the 3801GHV router   ~ both LAN and remote access, using port 8090. The second one works fine on the LAN, but I can’t seem to get the pinhole open for the second camera ( I’ve tried several ports). Any suggestions on how to proceed. I’ve already contacted Foscam support to no avail. They finally told me to check with uverse support.

Re: Viewing Foscam camera from outside my network?

624 views
0
(0)
  • Rate this reply
Jan 18, 2014 8:16:07 AM
0
(0)
Contributor

I recentely purchased a Foscam FI8910W (wireless IP camera) and cannot set up the remote access. I'm having difficulties with the port forwarding. The directions do not show what to do for an AT&T router. 

Re: Viewing Foscam camera from outside my network?

438 views
Share this post
Share this post