02-23-2013 12:41:02 PM
I have a wireless Foscam camera which worked just fine for weeks. I was able to configure it to view it from outside my network and on my phone. This was before i got U-verse internet. Since i have switched to U-verse i am not able to view my camera from outside my network (internally it works fine using the private IP). I have setup port forwarding by reading the various posts but haven't had much luck.
Has anyone gotten past this issue? Do i need to revert to using my Cisco router to configure this or I should be able to set this up by just having the AT&T wireless gateway?
Solved! Go to Solution.
02-23-2013 12:55:28 PM
02-23-2013 09:01:40 PM
12-13-2013 07:00:57 AM
I’m having an issue with a Foscam camera that I just can’t figure out. I have two of them. One of them I got set up and working fine on the 3801GHV router ~ both LAN and remote access, using port 8090. The second one works fine on the LAN, but I can’t seem to get the pinhole open for the second camera ( I’ve tried several ports). Any suggestions on how to proceed. I’ve already contacted Foscam support to no avail. They finally told me to check with uverse support.