04-17-2013 09:45:40 AM
Solved! Go to Solution.
04-17-2013 09:55:16 AM
att/ok - 955 - enter Will change to volume follows mode button.
att/ok-955-aux-enter will change to ALWAYS control Sony.
How about power?
att/ok-977-att-tv-aux-enter will add aux to power sequence.
Note that enter is bottom right (Not the OK button)
04-17-2013 11:11:38 AM
Here is a link with remote specific directions - http://www.att.com/esupport/article.jsp?sid=KB4090
If you do not find it post if your remote is gray or black & I will look it up.
04-17-2013 11:22:36 AM
you searched got it programmed & were able to determine the code.
04-17-2013 11:23:45 AM
04-17-2013 12:32:39 PM
Except for volume & power, other buttons may or may not work. Often menu or tv/video buttons do not work.
All you can do with the U-verse remote is keep looking for a code that provides more robust support.
For full support you need a Logitech Harmony. Harmony also has direct functions that do not appear as buttons. For example, it has HDMI1 & HDMI2. No need to navigate the menu. Change inputs with one button press.
04-22-2013 07:06:08 AM
Thanks for the info
Hey Jason - If your issue has been solved to your satisfaction, please mark the solution or solutions as "accepted solutions" that helped you, so that others will know where to turn.
Ironically, I bought both a Sony soundbar and a Samsung TV, this weekend!
04-23-2013 08:20:14 AM
For those curious,remote code 4029 under the "Aux" mode, worked for my Sony Soundbar. I gave up trying the auto find for the soundbar as it turned the TV off several times. That code was from the Home Theater in a Box category.
I now have three devices to power on / off, from my single press of the U-Verse remote, power switch. It will be a hard habit to break - putting the remote down too quickly as we used to have only two devices.
11-29-2013 04:05:33 PM - edited 11-29-2013 04:07:18 PM
Definite Kudos on the att/ok. This worked for my Motorola DVR to Sony STR-K700 surround sound. You would think ATT would put this in the manual.
12-03-2013 03:47:36 PM
If you got the Sony bar that has the HDMI through (newer generation of Sony HTCT260, and all HTCT660)
, and your TV supports CEC (Consumer Electronics Control) the set up can be hooked up the following way:
1. Cable Box to Sony Bar - HDMI
2. Sony bar to TV - HDMI
Make sure the TV is set to use CEC (check the manual, as only 1 or 2 TV HDMI inputs on your TV usually support CEC), and then your TV will automatically control your SONY bar volume. Either way, if HDMI is an option, go through the expense and hook that up, avoid analog connections.