- AT&T Forums Home
- /
- Wireless Forums
- /
- Phones & Devices
- /
- 3G MicroCell™
- /
- Re: MicroCell Troubleshooting Guide with Port Forw...
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Re: MicroCell Troublesho oting Guide with Port Forwarding - Error Message
[ Edited ]
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
09-26-2012
08:38:53 PM
- last edited on
10-19-2012
01:27:12 PM
by
jamileh
Thank you for this post. When I followed the procedure, though, I received a message saying that I didn't have a DNS - this occured when I changed Configure IPv4 to "Manually" instead of using the default "Using DCHP". After saving and updating, I then lost my Web connection, and the Microcell problem was still there.
Do I need to enter the DNS manually? Or, can I leave "Using DHCP" as the Configure IPv4 setting?
<CM Edit - new thread created, subject edited, link added>
Re: MicroCell Troublesho oting Guide with Port Forwarding - Error Message
[ Edited ]
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
10-19-2012
12:52:34 PM
- last edited on
10-19-2012
01:27:20 PM
by
jamileh
Hmmm, it's been awhile since I configured my router and I took careful notes while doing it in case I had to do it all over again. I would think that Using DHCP would be the correct setting because you've already assigned a static IP address to the MicroCell so there's no reason for it to be assigned again everytime you lose power and Using DHCP is necessary for the other connections (at least in my case).
For MicroCell Setup and Basic Troubleshooting, use this link.
For additional help, please send a PM to ATTCustomerCare.









